联系我们

咨询热线：020-36703438

电话：020-36703438

传真：020-36703488

邮箱：ccsopower@163.com

地址：广州市白云区夏花二路29号（旧广花路段）

当前位置: 首页 » 新闻中心

铅酸蓄电池固化室必须满足的条件

① 采用电热或热源，确保固化过程温度可控；
② 采用湿源（发出蒸汽）确保相对湿度能在100 % -O 变化；③ 堆放生极板的叠板架。
固化与干燥两个过程工艺要分开，对于涂膏后的极板，干燥早期可能还会有一点固化过程；而在固化过程几乎没有一点干燥过程。固化有助于在与铅青接触的板栅表面形成腐蚀层（结合层），它还能使铅膏中游离铅含量降至最低（3 ％以下），并且在控制温度与湿度下确立3BS-4BS 平衡体系的建立。

①Adopt an electricity hot or hot source, ensure that the temperature that is solid to turn process can control;
②Adopting a wet source(send out steam) ensures that the relative humidity can change in 100%-O;③Pile to living pole knothole to fold a plank.
Is solid to turn to want with two dry process crafts to separate, for the pole plank after applying ointment, the aridity was probably also a little bit solid to turn process in early days;But almost have no a little dry process in the process of being solid to turn.Is solid to turn to contribute to at and the plank grid surface formation corrosion layer(combine a layer) of lead green contact, it can also make to visit to leave a lead content to decline to in the lead cream lowest(below 3%), and establish the establishment of 3 BS BSs-4s equilibrium system while controling temperature and degree of humidity.

-> 蓄电池阅读相关文章

1 蓄电池成为今后20年最有发展前景的行业之一